Ham Radio AllStar Link EchoLink Full Duplex Repeater 440MHz UHF Motorola MCS2000

  

This listing is for a complete repeater for the 70 cm amateur radio band. Allstar and echo link work and frequencies anywhere between 440-470MHz are valid. You will need 12 volts and either two antennas or a duplexer to use this as a repeater. This node utilizes the top of the line Motorola MCS2000 UHF transceiver, and the radio has been modified by me for use as a AllStar simplex node. Please enter your programming configuration here when you are ready!

Additional delays may occur for parts ordering wait times. The frequency, AllStar Link configuration, and EchoLink configuration is included for free. Connect Raspberry pi to an ethernet internet connection. Go to the frequency with your 70cm meter mobile or portable radio, and enjoy worldwide connections. If you put a good antenna on the node at a good location, the range can exceed 10 miles, and you will make use out of a very quiet radio band. A short instruction sheet will be included. Tested Motorola MCS2000 Mobile Radio for repeater radio. USB interface hand built to interface audio and signalling connections to the raspberry pi.

Raspberry pi running AllStar link, and custom configured to your CallSign configuration. (Raspberry pi case may vary, the one in the photo was what was on hand at the taking of the photos). Mini UHF to SO-239 so you can plug in a PL259 based antenna.

Please submit programming info shortly after you pay, so I know what to put in your radio. Each Radio is individually tested and in spec to. TX Power: 6 to 25 WATTS.