Custom Build Dsp-sdr All Band Receiver, 3.5inch LCD Touch Screen

  

The 20-foot dipole antenna comes with a 10-1/2foot RG316 cable and a SMA male connector that will connect to the back of the receiver, recommended to install outdoor, but can be used inside the home. Weather bands will receive in NFM mode. If you have any questions, feel free to ask.

Below is the detail information on the functionality of the receiver; please read. Note: Quick press start button 3 times to turn on. The improvement of receiver circuit is as follows.

1 The circuit board of the receiver adopts 4 layer PCB. 2 The receiving circuit is shielded from interference. 3 Select high quality crystal oscillator to improve performance. Version:V1.10a(no need for future updates). 1 The radio is built on the principle of SDR-the function is determined by loaded software. 2 Frequency range: 50KHz to 2GHz. 13 Connect to computer via USB, which can transfer CAT, IQ and audio. 14 160 kHz span, with scalability; 15 Sensitivity: Under the condition of up to 250MHz, s/w is 0.3µV = 10dB; due to lack of measurement equipment, so the above measurements were not taken; 16 Due to the characteristics of msi001 chip used, dynamic blocking range is about 85dB. 17 With backlight control; 18 SMA female antenna socket; 19 Motherboard size: 100 x 70mm (without the sizes of connectors). This item is in the category "Consumer Electronics\Radio Communication\Ham, Amateur Radio\Ham Radio Receivers". The seller is "us_lemu" and is located in this country: US.

This item can be shipped to United States.

• Supported Modes: AM, CW, FM, SSB
• Custom Bundle: Yes
• Color: Gray
• Band: HF, AM, AM/FM, FM
• Year Manufactured: 2023
• Number of Outputs: 1
• Brand: SIGMA 3D CUSTOM
• Type: Tuner
• Manufacturer Warranty: 1 Month
• Number of Inputs: 1
• Model: 50K2G-1
• Features: Analog, Digital
• Country/Region of Manufacture: United States
• Power: 10 W